Drivers for Parallel Products
Below is the
software drivers for parallel products. Each is a self-extracting .EXE
file which, when executed after being downloaded, allows you to reconstruct
all the files found on a regular installation diskette. You can save the
extracted files on a diskette or in a directory on your hard disk and later
install the software from there.
!!! IMPORTANT !!!
After extracting any software, please first read the associated "README"
file which contains useful installation and troubleshooting information.
When you click to download any item below, your Web Browser may complain about
the file format. Proceed and select "Load To Disk" or "Save
as..." or equivalent and save it to a file.
!!! CAUTION !!! Before
downloading, please check your product model and select the appropriate version
of software. Note that 16-bit driver is for DOS and Windows 3.xx, and also
works in MS-DOS compatibility mode under Windows 95. 32-bit driver is for
Windows 95 and Windows NT.
*Installation script (fit.inf) updated for Win 2000
(4/18/00)
For TransDisk 3000 EPP (unit with
square 3-pin power connector);
TransCD (ATAPI, 4x or higher);
TransCD/PD; and TransPorter.
BUT NOT for TransDisk 2000;
older (before May'95) non-ATAPI (1x
or 2x) TransCD;
older non-EPP TransDisk 3000 (unit
with round power connector).
For TransDisk 3000 EPP (with square 3-pin power
connector) and TransCD (ATAPI, 4x or
higher) only.
Not for other models.
For 32-bit driver, see FIT32.EXE
above.
*Low-level format utility added,
Readme.tpd updated(5/7/97)
For 32-bit driver, see FIT32.EXE
above.
For 32-bit driver, see FIT32.EXE above.
For TransDisk 2000 (with battery
compartment) and
older non-EPP TransDisk 3000 (with
round power
connector) only. Not for other
models.
32-bit driver is NOT available for
these products.
For TransCD single- or double-speed (models
TCD-P or TCD2X-P) only. Not for other
models.
32-bit driver is NOT available for
this product.